HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 473)

HEIDENHAIN iTNC 530 473
1
7.7 F
A
S
T
PR
OBING (Cy
c
le 441, DIN/ISO:
G441, FCL 2 function)
Cycle parameters
 Positioning feed rate Q396: Define the feed rate at
which the touch probe is moved to the specified
positions. Input range 0 to 99999.9999
 Positioning feed rate=FMAX (0/1) Q397: Define
whether the touch probe is to move at FMAX (rapid
traverse) to the specified positions:
0: Move at feed rate from Q396
1: Move at FMAX
If your machine provides separate potentiometers for
rapid traverse and feed rate, the feed rate can only be
controlled with the feed-rate potentiometer even if
you enter Q397=1.
 Angle tracking Q399: Define whether the TNC is to
orient the touch probe before each probing process:
0: Do not orient
1: Orient the spindle before each probing process to
increase the accuracy
 Automatic interruption Q400: Define whether the
TNC is to interrupt program run and display the
measurement results on the screen after a measuring
cycle for automatic workpiece measurement:
0: Never interrupt the program run, not even if the
output of the measurement results on the screen is
selected in the respective probing cycle.
1: Always interrupt program run and display the
measurement results on the screen. To continue the
program run, press the NC Start button.
Beispiel: NC blocks
5 TCH PROBE 441 FAST PROBING
Q396=3000 ;POSITIONING FEED RATE
Q397=0 ;SELECT FEED RATE
Q399=1 ;ANGLE TRACKING
Q400=1 ;INTERRUPTION