HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 14)

14
Chang
e
d cy
cle functions of sof
tw
a
re
60642x
-0
1
Changed cycle functions of software
60642x-01
 The approach behavior during side finishing with Cycle 24 (DIN/ISO:
G124) has been changed (siehe „Please note while programming:”
auf Seite 200)
Changed cycle functions of software
60642x-02
 Position of the soft key for defining Cycle 270 has been changed
Changed cycle functions of software
60642x-04
 Cycle 206: The TNC now monitors the thread pitch if entered in the
tool table
 Cycle 207: The TNC now monitors the thread pitch if entered in the
tool table
 Cycle 209: The TNC now monitors the thread pitch if entered in the
tool table
 Cycle 209: The TNC now retracts the tool completely from the hole
for chip breaking if the parameter Q256=0 is defined (retraction rate
for chip breaking)
 Cycle 202: The TNC does not retract the tool for disengaging at the
bottom of the hole if the parameter Q214=0 is defined (disengaging
direction)
 Cycle 405: The TNC now also writes the datum in line 0 of the datum
table if the parameter Q337=0 is defined
 Relevant touch probe cycles 4xx: The input range of parameter
Q305 (number in table) has been increased to 99999
 Cycle 451 and Cycle 452: During a measurement, the TNC now
closes the status window only if the distance to the calibration
sphere is greater than the radius of the ball tip