HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 302)

302 Cycles: Coordinate Transformations
1
1
.9 W
O
RKING PLANE (Cy
c
le 1
9
, DIN/ISO:
G80, Sof
tw
a
re
Option 1)
Procedure for working with Cycle 19 WORKING
PLANE
1 Write the program
 Define the tool (not required if TOOL.T is active), and enter the full
tool length.
 Call the tool
 Retract the tool in the tool axis to a position where there is no
danger of collision with the workpiece or clamping devices during
tilting.
 If required, position the rotary axis or axes with an L block to the
appropriate angular value(s) (depending on a machine parameter).
 Activate datum shift if required.
 Define Cycle 19 WORKING PLANE; enter the angular values for the
tilt axes
 Traverse all principal axes (X, Y, Z) to activate compensation.
 Write the program as if the machining process were to be executed
in a non-tilted plane.
 If required, define Cycle 19 WORKING PLANE with other angular
values to execute machining in a different axis position. In this case,
it is not necessary to reset Cycle 19. You can define the new angular
values directly.
 Reset Cycle 19 WORKING PLANE; program 0° for all tilt axes.
 Disable the WORKING PLANE function; redefine Cycle 19 and
answer the dialog question with NO ENT.
 Reset datum shift if required.
 Position the tilt axes to the 0° position if required.
2 Clamp the workpiece
3 Preparations in the operating mode
Positioning with Manual Data Input
Pre-position the rotary axis/axes to the corresponding angular value(s)
for setting the datum. The angular value depends on the selected
reference plane on the workpiece.