HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 297)

HEIDENHAIN iTNC 530 297
1
1
.9 W
O
RKING PLANE (Cy
c
le 1
9
, DIN/ISO:
G80, Sof
tw
a
re
Option 1)
Cycle parameters
 Rotary axis and tilt angle? : Enter the axes of
rotation together with the associated tilt angles. The
rotary axes A, B and C are programmed using soft
keys. Input range -360.000 to 360.000
If the TNC automatically positions the rotary axes, you can enter the
following parameters:
 Feed rate? F= : Traversing speed of the rotary axis
during automatic positioning. Input range 0 to
99999.999
 Set-up clearance? (incremental): The TNC positions
the swivel head so that the position that results from
the extension of the tool by the set-up clearance does
not change relative to the workpiece. Input range 0 to
99999.9999
Reset
To cancel the tilt angles, redefine the WORKING PLANE cycle and
enter an angular value of 0° for all axes of rotation. You must then
program the WORKING PLANE cycle once again and respond to the
dialog question with the NO ENT key to disable the function.
Z S
S
S-S
X
B
Y
X
C
Danger of collision!
Please note that the set-up clearance in Cycle 19 does not
refer to the upper edge of the workpiece (as is the case in
the fixed cycles) but rather to the active datum.