HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 385)

HEIDENHAIN iTNC 530 385
15.8 D
A
TUM FR
OM OUTSIDE OF CORNER (Cy
c
le 414, DIN/ISO:
G414)
Please note while programming:
X
Y
X
Y
X
Y
X
Y
A B
C D
1 2
3
2 1
3
1 2
3
2 1
3
Before a cycle definition you must have programmed a
tool call to define the touch probe axis.
The TNC always measures the first line in the direction of
the minor axis of the working plane.
By defining the positions of the measuring points 1 and 3
you also determine the corner at which the TNC sets the
datum (see figure at right and table below).
Corn
er
X coordinate Y coordinate
A Point 1 greater than point
3
Point 1 less than point 3
B Point 1 less than point 3 Point 1 less than point 3
C Point 1 less than point 3 Point 1 greater than point 3
D Point 1 greater than point
3
Point 1 greater than point 3