HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 318)

318 Cycles: Special Functions
12.6 ENGRA
V
ING (Cy
c
le 225, DIN/ISO:
G225)
Cycle parameters
 Engraving text QS500: Text to be engraved inside
quotation marks. Assignment of a string variable
through the Q key of the numerical keypad. The Q key
on the ASCI keyboard represents normal text input.
Allowed entry characters: Siehe „Engraving system
variables”, Seite 320
 Character height Q513 (absolute): Height of the
characters to be engraved in mm. Input range 0 to
99999.9999
 Space factor Q514: The font used is a proportional
font. Each character has its own width, which is
engraved correspondingly by the TNC if you program
Q514 = 0. If Q514 is not equal to 0, the TNC scales
the space between the characters. Input range 0 to
9.9999
 Font Q515: Currently without function
 Text on a line/on an arc (0/1) Q516:
Engrave text in a straight line: Input = 0
Engrave text on an arc: Input = 1
 Angle of rotation Q374: Center angle if the text is to
be arranged on an arc. Engraving angle if the text is
arranged in a straight line. Input range -360.0000 to
+360.0000°
 Radius of text on an arc Q517 (absolute): Radius of
the arc in mm on which the TNC is to arrange the text.
Input range 0 to 99999.9999
 Feed rate for milling Q207: Traversing speed of the
tool in mm/min while engraving. Input range 0 to
99999.999; alternatively FAUTO, FU or FZ
 Depth Q201 (incremental value): Distance between
workpiece surface and engraving floor
 Feed rate for plunging Q206: Traversing speed of
the tool in mm/min when moving into the workpiece.
Input range 0 to 99999.999; alternatively FAUTO, FU
 Set-up clearance Q200 (incremental): Distance
between tool tip and workpiece surface. Input range
0 to 99999.9999; alternatively PREDEF
 Coordinate of workpiece surface Q203 (absolute):
Coordinate of the workpiece surface. Input range
-99999.9999 to 99999.9999
 2nd set-up clearance Q204 (incremental): Coordinate
in the spindle axis at which no collision between tool
and workpiece (fixtures) can occur. Input range 0 to
99999.9999; alternatively PREDEF
Beispiel: NC blocks
62 CYCL DEF 225 ENGRAVING
QS500="TXT2" ;ENGRAVING TEXT
Q513=10 ;CHARACTER HEIGHT
Q514=0 ;SPACE FACTOR
Q515=0 ;FONT
Q516=0 ;TEXT LAYOUT
Q374=0 ;ANGLE OF ROTATION
Q515=0 ;CIRCLE RADIUS
Q207=750 ;FEED RATE FOR MILLING
Q201=-0.5 ;DEPTH
Q206=150 ;FEED RATE FOR PLNGNG
Q200=2 ;SET-UP CLEARANCE
Q203=+20 ;SURFACE COORDINATE
Q204=50 ;2ND SET-UP CLEARANCE