HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 72)

72 Fixed Cycles: Drilling
3.2 CENTERING (Cy
c
le
240, DIN/ISO:
G240)
Cycle parameters
 Set-up clearance Q200 (incremental): Distance
between tool tip and workpiece surface. Enter a
positive value. Input range 0 to 99999.9999;
alternatively PREDEF
 Select Depth/Diameter (1/0) Q343: Select whether
centering is based on the entered diameter or depth.
If the TNC is to center based on the entered diameter,
the point angle of the tool must be defined in the T-
ANGLE
column of the tool table TOOL.T.
0: Centering based on the entered depth
1: Centering based on the entered diameter
 Depth Q201 (incremental): Distance between
workpiece surface and centering bottom (tip of
centering taper). Only effective if Q343=0 is defined.
Input range -99999.9999 to 99999.9999
 Diameter (algebraic sign) Q344: Centering
diameter. Only effective if Q343=1 is defined. Input
range -99999.9999 to 99999.9999
 Feed rate for plunging Q206: Traversing speed of
the tool in mm/min during centering. Input range 0 to
99999.999; alternatively FAUTO, FU
 Dwell time at depth Q211: Time in seconds that the
tool remains at the hole bottom. Input range 0 to
3600.0000; alternatively PREDEF
 Coordinate of workpiece surface Q203 (absolute):
Coordinate of the workpiece surface. Input range
-99999.9999 to 99999.9999
 2nd set-up clearance Q204 (incremental): Coordinate
in the spindle axis at which no collision between tool
and workpiece (fixtures) can occur. Input range 0 to
99999.9999; alternatively PREDEF
Beispiel: NC blocks
10 L Z+100 R0 FMAX
11 CYCL DEF 240 CENTERING
Q200=2 ;SET-UP CLEARANCE
Q343=1 ;SELECT DEPTH/DIA.
Q201=+0 ;DEPTH
Q344=-9 ;DIAMETER
Q206=250 ;FEED RATE FOR PLNGNG
Q211=0.1 ;DWELL TIME AT DEPTH
Q203=+20 ;SURFACE COORDINATE
Q204=100 ;2ND SET-UP CLEARANCE
12 CYCL CALL POS X+30 Y+20 Z+0 FMAX M3
13 CYCL CALL POS X+80 Y+50 Z+0 FMAX
X
Z
Q200
Q344
Q206
Q210
Q203
Q204
Q201
30
X
Y
20
80
50