HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 358)

358 Touch Probe Cycles: Automatic Datum Setting
15.1 F
undamentals
15.1 Fundamentals
Overview
The TNC offers twelve cycles for automatically finding reference
points and handling them as follows:
 Setting the determined values directly as display values
 Entering the determined values in the preset table
 Entering the determined values in a datum table
Cycle Soft key Page
408 SLOT CENTER REF PT. Measuring
the inside width of a slot, and defining
the slot center as datum Seite 361
409 RIDGE CENTER REF PT. Measuring
the outside width of a ridge, and defining
the ridge center as datum Seite 365
410 DATUM INSIDE RECTANGLE
Measuring the inside length and width of
a rectangle, and defining the center as
datum Seite 368
411 DATUM OUTSIDE RECTANGLE
Measuring the outside length and width
of a rectangle, and defining the center as
datum Seite 372
412 DATUM INSIDE CIRCLE Measuring
any four points on the inside of a circle,
and defining the center as datum Seite 376
413 DATUM OUTSIDE CIRCLE
Measuring any four points on the
outside of a circle, and defining the
center as datum Seite 380
414 DATUM OUTSIDE CORNER
Measuring two lines from the outside of
a corner, and defining the intersection as
datum Seite 384
415 DATUM INSIDE CORNER
Measuring two lines from the inside of a
corner, and defining the intersection as
datum Seite 389
416 DATUM CIRCLE CENTER (2nd soft-
key row) Measuring any three holes on a
bolt hole circle, and defining the bolt-
hole circle center as datum Seite 393