HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 393)

HEIDENHAIN iTNC 530 393
15.1
0
D
A
TUM CIR
C
LE CENTER (Cy
c
le
416, DIN/ISO:
G416)
15.10 DATUM CIRCLE CENTER
(Cycle 416, DIN/ISO: G416)
Cycle run
Touch Probe Cycle 416 finds the center of a bolt hole circle by
measuring three holes, and defines the determined center as the
datum. If desired, the TNC can also enter the coordinates into a datum
table or the preset table.
1 Following the positioning logic (siehe „Executing touch probe
cycles” auf Seite 334), the TNC positions the touch probe at rapid
traverse (value from MP6150) to the point entered as center of the
first hole
1 .
2 Then the touch probe moves to the entered measuring height and
probes four points to find the first hole center.
3 The touch probe returns to the clearance height and then to the
position entered as center of the second hole
2 .
4 The TNC moves the touch probe to the entered measuring height
and probes four points to find the second hole center.
5 The touch probe returns to the clearance height and then to the
position entered as center of the third hole
3 .
6 The TNC moves the touch probe to the entered measuring height
and probes four points to find the third hole center.
7 Finally the TNC returns the touch probe to the clearance height and
processes the determined datum depending on the cycle
parameters Q303 and Q305 (siehe „Saving the calculated datum”
auf Seite 360) and saves the actual values in the Q parameters
listed below.
8 If desired, the TNC subsequently measures the datum in the touch
probe axis in a separate probing.
X
Y
1
2
3
Parameter number Meaning
Q151 Actual value of center in reference axis
Q152 Actual value of center in minor axis
Q153 Actual value of bolt hole circle diameter