HEIDENHAIN iTNC 530 (60642x-04) Cycle programming - Manual (Page 319)

HEIDENHAIN iTNC 530 319
12.6 ENGRA
V
ING (Cy
c
le 225, DIN/ISO:
G225)
Allowed engraving characters
The following special characters are allowed in addition to lowercase
letters, uppercase letters and numbers:
! # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ \ ] _
You can also use the cycle to engrave German umlauts and the
diameter symbol::
Characters that cannot be printed
Apart from text, you can also define certain non-printable characters
for formatting purposes. Enter the special character \ before the non-
printable characters.
The following formatting possibilities are available:
 \n : Line break
 \t : Horizontal tab (the tab width is permanently set to 8 characters)
 \v : Vertical tab (the tab width is permanently set to one line)
The TNC uses the special characters % and \ for special
functions. These characters must be indicated twice in the
text to be engraved (e.g. %%) if you want to engrave them.
Character Input
ä %ae
ö %oe
ü %ue
Ä %AE
Ö %OE
Ü %UE
ø %D