beautypg.com

Tool life monitoring, 4 set ting up a t ool list – HEIDENHAIN SW 68894x-02 User Manual

Page 88

background image

88

Machine mode of operation

3.4 Set

ting up a t

ool list

Tool life monitoring

If desired, you can have the CNC PILOT monitor tool life or the number

of parts that are produced with a specific tool.
The tool life monitoring function adds the time a tool is used at feed

rate. The quantity monitoring counts the number of finished parts. The

count is compared with the entry in the tool data.
As soon as the tool life expires or the programmed quantity is reached,

the CNC PILOT generates an error message and stops program

execution after the end of the program. If you are working with

program repeats (M99 in DIN programs), the system is stopped after

execution of the current repeat.

For Teach-in programs, the simple tool life monitoring is available.

Here CNC PILOT informs you when a tool is worn out.

In smart.Turn and DIN PLUS programs, you have the choice

between the simple tool life monitoring or the tool life

monitoring with replacement tools

option. If you use

replacement tools, the CNC PILOT automatically inserts the "sister

tool" as soon as the tool is worn-out. The CNC PILOT does not stop

the program run until the last tool of the tool sequence of exchange

is worn out.

You activate/deactivate the tool life management in the parameter

"System/General settings for automatic operation/user parameter tool

life."
The type of monitoring data, the "tool life/remaining tool life" or the

"maximum number of pieces/remaining number of pieces" are

managed in the tool data. They are also edited and displayed in the tool

data (see "Editing tool-life data" on page 491).
You can define replacement tools when setting up the turret. The

"interchange chain" can contain more than one replacement tool. The

interchange chain is part of the NC program (see chapter titled "Tool

Programming" in the "smart.Turn and DIN Programming" User's

Manual.)

You must update the data on tool life and number of

pieces in the "tool management" mode when you replace

the insert of a tool.