HEIDENHAIN SW 68894x-02 - Manual (Page 363)

HEIDENHAIN CNC PILOT 640 363
5.2 ICP edit
or in cy
cle mode
5.2 ICP editor in cycle mode
In cycle mode you can create:
 Complex workpiece blank contours
 Contours for turning
 For ICP turning cycles
 For ICP recessing cycles
 For ICP recess-turning cycles
 Complex contours for milling with the C axis
 For the face
 For the lateral surface
You activate the ICP editor with the Edit ICP soft key. This can only
be selected when editing ICP turning cycles or milling cycles or the
ICP workpiece blank contour cycle.
The description depends on the contour type. Using the cycle, ICP
distinguishes between:
 Contour for turning or the workpiece blank contour: See "Contour
elements of a turning contour" on page 387.
 Contour for the face: See "Face contours in smart.Turn" on
page 413.
 Contour for the lateral surface: See "Lateral surface contours in
smart.Turn" on page 421.
Editing contours for cycles
The ICP contours of the cycle editing function are assigned names.
The contour name is the same as the file name. The contour name is
also used in the calling cycle.
You can define the contour name in the following ways:
 Define the contour name in the cycle dialog before calling the ICP
editor (input field FK). ICP loads this name.
 Define the contour name in the ICP editor. The input field FK has to
be empty when you call the ICP editor.
 Load the existing contour. When you exit the ICP editor, the name
of the contour last edited is loaded into the input field FK.
If you create/edit two or more ICP contours in sequence,
the last edited "ICP contour number" is loaded to the cycle
after the ICP editor is exited.