HEIDENHAIN SW 68894x-02 - Manual (Page 108)

108 Machine mode of operation
3.9
Pr
ogr
am
Run
mode
Comparing a tool list
While a program is being loaded, the CNC PILOT compares the current
tools in the turret with the tool list of the program. If tools are used in
the program that are not in the current turret list or are located in
another pocket, an error message is displayed.
After the error message is confirmed, the program-dependent tool list
is shown for checking.
You can transfer the programmed tool table with the Load tool soft
key, or cancel the program selection with Cancel.
Before executing a program
Faulty programs
The CNC PILOT checks the programs during loading up to the
MACHINING section. If it detects an error (for example, an error in the
contour description), it displays the error symbol in the screen
headline. You can then press the Info key for detailed information on
the error.
The machining section of a program and therefore all traverse is not
interpreted until after Cycle on. If there is an error here, the machine
stops with an error message.
 Testing the cycles and cycle parameters
The CNC PILOT displays the Teach-in program or the DIN program
in the list window. With Teach-in programs, the parameters of the
cycle on which the cursor is placed are displayed.
 Graphic control
You can monitor program run with the graphic simulation feature
(see "Simulation mode of operation" on page 468).
Danger of collision!
 Load the programmed tool list only if it matches the
actual turret assignment.
 A program start is not possible unless the programmed
tool list matches the turret list that was set up.
Danger of collision!
Before starting the program, check it in the simulation to
find errors in the programming or the syntax used.