Last cut, 6 thr ead and under cut cy cles – HEIDENHAIN SW 68894x-02 User Manual

Page 260

260

Teach-in mode

4.6

Thr

ead

and

under

cut

cles

Last cut

After the cycle is finished, the CNC PILOT presents the Last cut

option. In this way you can enter a tool compensation value and repeat

the last thread cut.

Initial situation: The thread cut cycle has been run, and the thread

depth is not correct.

Perform the tool compensation

Press the Last cut soft key

Activate Cycle Start

Check the thread

SEQUENCE OF THE "LAST CUT" FUNCTION

The tool compensation and the last cut can be repeated

as often as necessary until the thread is correct.