2 pa ra met ers – HEIDENHAIN SW 68894x-02 User Manual
Page 528

528
Organization mode of operation
8.2
Pa
ra
met
ers
Coolant for new units
Default setting for the coolant (start unit: CLT parameter):
0: Without coolant
1: Coolant circuit 1 on
2: Coolant circuit 2 on
Protection zone "G60" for new units
Default setting for the protection zone (start unit: G60
parameter):
0: Active
1: Inactive
Global safety clearance G47
Default setting for the global safety clearance (start unit: G47
parameter)
Global safety clearance G147 in the plane
Default setting for the global safety clearance in the plane (start
unit: G147 parameter)
Global safety clearance G147 in infeed direction
Default setting for the global safety clearance in infeed
direction (start unit: G147 parameter)
Global oversize in X direction
Default setting for the global safety clearance in X direction
(start unit: I parameter)
Global oversize in Z direction
Default setting for the global safety clearance in X direction
(start unit: K parameter)
Rotational direction for new units
Default for the spindle direction of rotation MD when creating/
opening a new unit ("Tool" tab)
Front edge of chuck on main spindle
Z position of the front edge of the chuck for calculating the
workpiece zero point (AWG)
Front chuck edge on counterspindle
Z position of the front edge of the chuck for calculating the
workpiece zero point (AWG)
Jaw width on main spindle
Jaw width in Z direction for calculating the workpiece zero point
(AWG)
Jaw width on counterspindle
Jaw width in Z direction for calculating the workpiece zero point
(AWG)
Global safety clearance