HEIDENHAIN SW 68894x-02 - Manual (Page 286)

286 Teach-in mode
4.7
Dr
illing
cy
cles
Drilling, axial
Select drilling
Select drilling, axial
This cycle drills a hole on the face of the workpiece.
Cycle parameters
X, Z
Starting point
C Spindle angle (C-axis position)
Z1 Starting point of hole (default: drilling starts from Z)
Z2 End point drill (end point of hole)
E Dwell time for chip breaking at end of hole
(default: 0)
D Retraction type
 0: Rapid traverse
 1: Feed rate
AB Drilling lengths (default: 0)
V Through drilling variants (default: 0)
 0: No feed rate reduction
 1: Feed rate reduction at the end of the hole
 2: Feed rate reduction at the beginning of the hole
 3: Feed rate reduction at the beginning and end of the
hole
SCK Safety clearance (see page 128)
G60 Deactivate the protective zone for the drilling operation
 0: Active
 1: Inactive
G14 Tool change point (see page 128)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
BP Break duration: Time span for interruption of the feed. The
chip is broken by the (intermittent) interruption of the feed.
BF Feed duration: Time interval until the next break. The chip
is broken by the (intermittent) interruption of the feed.
MT M after T: M function that is executed after the tool call T