HEIDENHAIN SW 68894x-02 - Manual (Page 107)

HEIDENHAIN CNC PILOT 640 107
3.9
Pr
ogr
am
Run
mode
3.9 Program Run mode
Loading a program
In Program Run mode, you use Teach-in and DIN programs for parts
production. You cannot change the programs in this mode. The
graphic simulation feature, however, allows you to check the
programs before you run them. The CNC PILOT also offers the Single
Block
and the Continuous Run mode with which you can machine step
by step the first workpiece of a whole batch.
The smart.Turn programs are selected as DIN programs (*.nc).
Program Run automatically loads the most recently used program. To
load another program, proceed as follows:
Open the program list—the CNC PILOT displays the
Teach-in programs
Display the DIN program
Select the Teach-in program or DIN program
Display the DIN program
You can start a Teach-in or smart.Turn program at any desired block to
resume a machining operation after an interruption (mid-program
startup).
The Program Run mode can be switched on with the soft key and is
displayed in the header.
If you press Program Run, the CNC PILOT reads in the program that
was last active in this mode or in the editing mode. Alternately, you
can select another program with Program list (see "Program
management" on page 116).
LOAD THE TEACH-IN PROGRAM OR NC PROGRAM