HEIDENHAIN SW 68894x-02 - Manual (Page 546)

546 Organization mode of operation
8.3 T
ransf
er
8.3 Transfer
The Transfer mode is used for data backup and data exchange via
networks or USB devices. When we speak of "files" in the following,
we mean programs, parameters and tool data. The following file types
can be transferred:
 Programs (cycle programs, smart.Turn programs, DIN main and
subprograms, ICP contour descriptions)
 Parameters
 Tool data
Data backup
HEIDENHAIN recommends backing up the tool data and programs
created on CNC PILOT on an external device at regular intervals.
You should also back up the parameters. Since the parameters are not
changed very often, however, you only need to back up the
parameters from time to time, as required.
Data exchange with TNCremo
HEIDENHAIN offers the PC program TNCremo to complement the
CNC PILOT control. This program enables you to access the control
data from a PC.
External access
The soft key SERVICE can be used to grant or restrict access through
the LSV-2 interface.
Permitting/Restricting external access:
 Select the Organization mode
 Enable a connection to the control: Set the EXTERNAL
ACCESS soft key to ON. The TNC will then permit
data access through the LSV-2 interface.
 Disable connections to the control: Set the
EXTERNAL ACCESS soft key to OFF. The TNC will
then disable access through the LSV-2 interface
The machine tool builder can configure the external access
options. Refer to your machine manual.