HEIDENHAIN SW 68894x-02 - Manual (Page 126)

126 Teach-in mode
4.1
W
o
rk
ing
with
cy
cles
Cycle menu
The main menu shows the cycle groups (see table below). Once a
cycle group has been selected, the soft keys for the individual cycles
appear.
You can use ICP cycles for complex contours, and DIN macros for
technologically sophisticated machining operations. In cycle
programs, the names of the ICP contours or DIN macros are at the end
of the line of the cycle.
Some cycles offer optional parameters. That means, specific
contour elements will only be machined if you set the corresponding
parameters. The identification letters for optional parameters and
parameters that are preassigned default values are displayed in gray.
The following parameters are only required in Teach-in mode:
 Starting point X, Z
 Machine data S, F, T and ID
Cycle groups Menu key
Workpiece blank
Define standard workpiece blank or workpiece
blank with ICP
Single cuts
Position at rapid traverse, linear and circular single
cuts, chamfers, and rounding arcs
Turning cycles, longitudinal/transverse
Turning and finishing cycles for turning and facing
Recessing and recess-turning cycles
Cycles for recessing, contour recessing,
undercuts and parting
Thread cutting
Thread cycles, relief turns and thread repair
Drilling
Drilling cycles and patterns for face and lateral-
surface machining
Milling
Milling cycles and patterns for face and lateral
surface machining
DIN macros
Including DIN macros