HEIDENHAIN SW 68894x-02 - Manual (Page 495)

HEIDENHAIN CNC PILOT 640 495
7.
2
Tool
edit
or
You can create a new holder with the "New line" soft key. The new line
is always added at the end of the table.
You may only use ASCII characters in the holder table for
holder names. Diacritics or Asian characters are not
permitted.
You can also view and edit the holder table in opened tool
forms. Use the 'Holder Editor" soft key for this purpose on
the third form page (MTS entry).
If you use tool inserts in various manual change system
holders, you need to manage the tool setting dimensions
of the holder and tool insert separately. Enter the tool
setting dimensions of the tool inserts into the tool table.
Enter the tool setting dimensions of the manual change
system holders in the holder table.
Entries for the standard tool holders are currently not
evaluated. Thus management of the standard tool holders
is not necessary.