HEIDENHAIN SW 68894x-02 - Manual (Page 268)

268 Teach-in mode
4.6
Thr
ead
and
under
cut
cy
cles
Type of machining for technology database access: thread cutting
Parameter combinations for the taper angle:
 X1/Z1, X2/Z2
 X1/Z1, Z2, W
 Z1, X2/Z2, W
Cycle run
1 Calculate the proportioning of cuts
2 Move to thread starting point X1, Z1.
3 Move to end point Z2 at programmed feed rate, taking the run-
out angle WE
into account
4 Return on paraxial path and approach for next thread groove
5 Repeat 3 and 4 for all thread grooves
6 Approach for next pass, taking the reduced cutting depth and the
feed angle A
into account
7 Repeat 3 to 6 until no. threads D and depth U are reached.
8 Move to the tool change point according to the G14 setting
GH Type of offset
 0: Without offset
 1: From left
 2: From right
 3: Alternately left/right
A Approach (infeed) angle (range: –60° < A < 60°;
default 30°)
 A<0: Infeed on left thread flank
 A>0: Infeed on right thread flank
R Remaining cutting depth only with GV=4
(default 1/100 mm)
Q No. no load (number of dry runs)
MT M after T: M function that is executed after the tool call T
MFS M at beginning: M function that is executed at the
beginning of the machining step
MFE M at end: M function that is executed at the end of the
machining step
WP Displays which workpiece spindle is used to process the
cycle (machine-dependent)
 Main drive
 Opposing spindle for rear-face machining