HEIDENHAIN SW 68894x-02 - Manual (Page 10)

10
New functions of software 68894x-02
 The "Zero point shift" miscellaneous function was introduced in ICP
(see also "Zero point shift" on page 375)
 In ICP contours, fit dimensions and inside threads can now be
calculated using an input form (see also "Fits and inside threads" on
page 370)
 The "Copy Linear, Circular and Mirror" miscellaneous functions were
introduced in ICP (see also "Copying a contour section in linear
series" on page 375)
 The system time can now be set using an input form (see also
"Displaying operating times" on page 97)
 The parting cycle G859 was expanded by the parameters K, SD and
U (see also "Parting" on page 253)
 The ICP recess turning cycles now allow defining an approach and
departure angle (see also "ICP recess turning, radial finishing" on
page 244)
 With TURN PLUS you can now create programs for machining with
an opposing spindle and for multipoint tools (see the smart.Turn and
DIN Programming User’s Manual)
 In the G797 Area Milling function, milling contours can now be
selected (see the smart.Turn and DIN Programming User’s Manual)
 The G720 function was expanded by the Y parameter (see the
smart.Turn and DIN Programming User’s Manual)
 The G860 function was expanded by the O and U parameters (see
the smart.Turn and DIN Programming User’s Manual)