HEIDENHAIN SW 68894x-02 - Manual (Page 524)

524 Organization mode of operation
8.2
Pa
ra
met
ers
General settings :
Parameter: System / ... Meaning
... / Definition of the units of measure valid for the display (101100)
/ ...
... / Unit of measure for display and user interface (101101)
metric Use the metric system
inch Use the inch system
... / General settings for automatic operation (601800) / ...
.../ Service life management (601801)
ON Tool life monitoring is active
OFF Tool life monitoring is inactive
.../ End mid-program startup after start block (601810)
TRUE In mid-program startup, program execution begins
with the subsequent NC block
FALSE In mid-program startup, program execution begins
with the selected NC block
... / Tool measurement (604600)
Measuring feed rate [mm/min] (604602) Feed rate for approaching the touch probe
Measuring range [mm] (604603) The touch probe must be triggered within the
measuring range. Otherwise, an error message is
issued.