HEIDENHAIN SW 68894x-02 - Manual (Page 431)

HEIDENHAIN CNC PILOT 640 431
5.13
Lat
er
al
surf
ace
cont
ours
in
smar
t.T
u
rn
You can find the reference diameter XR with the "select reference
plane" function (see page 411).
ICP generates:
 The SURFACE section code with the reference dimension
parameter. In nested contours, ICP generates only one section
code.
 A G308 with the parameters contour name and milling depth
(-1*BT).
 A G412 with the parameters of the pattern.
 The G function and the parameters of the figure/hole.
 A G309.
EP End angle (no entry: the pattern elements are equally divided
into 360°)
EPi Angle between two figures
H Element position
 0: Normal – the figures are rotated about the circle center
(rotation)
 1: Original position – the position of the figures relative to
the coordinate system remains unchanged (translation)
Parameters of the selected figure/hole