HEIDENHAIN SW 68894x-02 - Manual (Page 306)

306 Teach-in mode
4.8
Milling
cy
cles
Cycle run
1 Activate the C axis and position to spindle angle C at rapid
traverse (only in Teach-in mode)
2 Calculate the proportioning of cuts
3 Approach at infeed rate FZ
4 Machine to end point of slot
5 Approach at infeed rate FZ
6 Machine to starting point of slot
7 Repeat 3 to 6 until the milling depth is reached
8 Position to starting point Z and deactivate C axis
9 Move to the tool change point according to the G14 setting