Grass Valley PVS Series System Guide v.4.0 Dec 10 200 - Manual (Page 267)

Fibre Channel Disk board connectors
July 27, 2001 Profile XP System Guide 267
Fibre Channel Disk board connectors
The Fibre Channel Disk board has two connectors labeled Port A and Port B. Both
connectors have the same pin-out. The interconnect cable has a Amphenal Metagig
connector on one end and DB-9 on the other. Pinouts for both ends of the cable are
shown here along with the Fibre Channel cable specifications.
Metagig Connector PInouts
DB-9 Connector Pinouts
Fibre Channel Cable Specifications
The Fibre Channel cable specifications are as follows:
Cable type: Shielded, 75 ohm twin axial
Maximum length: 30 meters (98 feet) between PFC500 and Profile XP system;
< or = 10m (33 feet) unequalized; >10 m (33 feet) equalized
0.3 m (1 foot) min., 10m (33 feet) max. between PFC 500 and PFC500E
Connector type: DB-9 on one end and Berg Metagig on the other.
Pin # Mnemonic Description
1 TXP H Differential Transmit Data (high)
2 GND Signal Ground
3 TXN L Differential Transmit Data (low)
4 NC
5 GND Signal Ground
6 RXN L Differential Receive Data (low)
7 Vcc +5VDC
8 RXP H Differential Receive Data (high)
9 GND Signal Ground
10 GND Signal Ground
Pin # Mnemonic Description
1 TXP H Differential Transmit Data (high)
2 Vcc +5VDC
3 GND Signal Ground
4 key
5 RXP H Differential Receive Data (high)
6 TXN L Differential Transmit Data (low)
7 GND Signal Ground
8 GND Signal Ground
9 RXN L Differential Receive Data (low)