Grass Valley PVS Series System Guide v.4.0 Dec 10 200 User Manual
Page 200

Chapter 9
Setting up a Simple Network
200
Profile XP System Guide
July 27, 2001
Choosing machine names and IP addresses for your Fibre Channel network
The default machine name for each Profile XP system is the unit serial number. You
may want to change the name to something more meaningful, such as
Profile1
or
Profile2
.
The video network option also requires you to set up two IP addresses for each Profile
XP unit, one for the Ethernet interface and the other for the Fibre Channel interface.
A common mistake is to choose IP addresses for the Fibre Channel and Ethernet
interfaces using the same network ID. This is wrong; the IP addresses for each
network must be unique.
Here is an example of IP addresses for two Profile XP systems:
Computer Name:
Profile1
Ethernet Address:
192.168.99.1
FC Address:
192.168.100.1
Computer Name:
Profile2
Ethernet Address:
192.168.99.2
FC Address:
192.168.100.2
You can use the these addresses if you want, but if you are connecting the Ethernet
interface to an existing network, check with your system administrator for the correct
names and IP addresses to use.
Use the table below to enter information you’ll need when you configure your video
network.
Refer to the procedures in “Setting up a simple video network: Fibre Channel” on
page 208, when you to set up the Fibre Channel video network.
Machine Name
Ethernet
IP Address
Fibre Channel
IP Address