Grass Valley PVS Series System Guide v.4.0 Dec 10 200 User Manual
Page 207
Power-on the hub or switch and configure if nec-
July 27, 2001
Profile XP System Guide
207
Power-on the hub or switch and configure if necessary
Refer to the your device’s vendor documentation to power-on and configure as
required.
Power-on and test each Profile XP system on the network
Use Network Neighborhood to test network configuration and connectivity.
To test the network:
1. Power-on two Profile XP systems.
2. Perform the following test on each Profile XP system:
a. On the desktop, click Network Neighborhood.
b. Verify that all systems on the network are listed. If the
Workgroup
icon appears,
you may have to double-click the
Workgroup
icon.
3. Power-on the next Profile XP system and wait for it to initialize, then repeat step 2.
Continue adding one system at a time until all Profile XP systems have been tested.
You may have to refresh the Network Neighborhood window to see new systems
displayed.
NOTE: If you have a problem, refer to Chapter 10, “Solving Common Setup
Problems”, on page 229.
Now that you have tested the network connections for all Profile XP systems, you are
ready to use the Ethernet network. If you are setting up an optional video network,
return to one of the following procedures:
“Setting up a simple video network: Fibre Channel” on page 208