Setting up the vitc reader on a video input – Grass Valley PVS Series System Guide v.4.0 Dec 10 200 User Manual
Page 178

Chapter 7
Modifying a Channel: Timecode Settings
178
Profile XP System Guide
July 27, 2001
Setting up the VITC reader on a Video Input
The VITC reader has two detection modes: Automatic and Manual. When you select
automatic detection, you can set the range of vertical interval lines scanned to find the
VITC signal pair; lines 10 to 21 by default. Manual allows you to choose specific line
numbers to detect the VITC signals. Automatic detection is the default setting. Use
automatic detection unless there are two sets of VITC on the input signal.
To set up the video input VITC reader:
1. Select Video Input in the Configuration Manager window. The Video Input dialog
box appears.
2. Click
Next
to navigate to Video Input page 2 of 3.
3. Select a video input from the list or click
Select All
to configure all video inputs at
the same time.