Setting up the vitc reader on the reference input – Grass Valley PVS Series System Guide v.4.0 Dec 10 200 User Manual
Page 180

Chapter 7
Modifying a Channel: Timecode Settings
180
Profile XP System Guide
July 27, 2001
Setting up the VITC reader on the Reference Input
The VITC reader has two detection modes: Automatic and Manual. When you select
automatic detection, you can set the range of vertical interval lines scanned to find the
VITC signal pair; lines 10 to 21 by default. Manual allows you to choose specific line
numbers to detect the VITC signals. Automatic detection is the default setting. Use
automatic detection unless there are two sets of VITC on the input signal.
To set up the Reference Input VITC reader:
1. Select Video Timing in the Configuration Manager window. The Video Timing
dialog box appears.
2. Click
Next
to navigate to Video Timing page 3 of 3.