Grass Valley Imagestore 750 v.2.0.1 User Manual
Page 395

Imagestore 750 User Manual
Software Update
Miranda Technologies Inc.
Page 395
corrupted. If the unit has problems powering up after such an event, then the
Software Update Recovery process can be performed as follows:
•
To the right of the Joystick on the unit front panel is a small hole,
behind which there is a button.
•
Use a paperclip to push this button in and power up the unit while
continuing to push the button. Keep button pressed for 15 seconds.
•
The unit should now boot using an emergency firmware image.
Once the unit has booted, carry out a software upgrade as before
with the CPIO archive file.
Warning: System reset switch must not be used in normal operation.
Notes on Upgrading from v1.14.1 to v2.0
On a system upgrade from version 1.14.x to version 2.0 or higher the
following parameters will be preserved:
•
Serial / automation level (Setup, System Setup, Serial Level)
•
Source input selections (Operate, Input Masks)
•
Source mask values (Operate, Set Inputs)
•
Colour field RGB values for each colour field (Operate, Colour
Fields
)
•
AB mixer settings
o
AB mixer input A (Operate, Mix A Input)
o
AB mixer input A (Operate, Mix B Input)
o
AB mixer cut mode (Operate, AB Mixer, Set Cut Mode)
•
2D DVE program settings
o
Router mode (Operate, 2D DVE (PGM), DVE Mode)
o
DVE 1 Input (Operate, 2D DVE (PGM), DVE 1 Input)
o
DVE21 Input (Operate, 2D DVE (PGM), DVE 2 Input)
•
2D DVE preview settings
o
Router mode (Operate, 2D DVE (PVW), DVE Mode)
o
DVE 1 Input (Operate, 2D DVE (PVW), DVE 1 Input)