Local logging, Time zone, Software reset – Grass Valley Imagestore 750 v.2.0.1 User Manual
Page 183: Restart system

Imagestore 750 User Manual
Front Panel Operations
Miranda Technologies Inc.
Page 183
Local Logging
This option enables or disables local logging to the hard disk or solid state
storage. Disabling local logging this can reduce wear to the internal hard disk
or solid state storage, but it should usually only be disabled if a logging
server has been set up (see above).
Time Zone
Use this option to set the time zone offset from GMT (+/-) in hours, minutes
and seconds.
Software Reset
This option safely restarts the system software and reloads the firmware. A
restart is needed after certain settings (such as video standard) are changed.
Software Reset should usually complete in approximately 16 seconds, and so
it is considerably faster than Restart System.
Note:
Always avoid turning off the power to restart the system since
this may not allow cached files or configurations to be saved to
disk.
The system settings that are restored after the restart depend upon the Active
Configuration, as described on page 123.
To confirm the restart select “Yes” and press enter to confirm.
Restart System
This option safely reboots the system by restarting the operating system and
software, and reloading the firmware. A restart is needed after certain settings
(such as video standard) are changed.
Restart System should usually complete in around 50 seconds.