Grass Valley Concerto Routing Matrix v.1.8.1 - Manual (Page 164)

164 Concerto — Installation and Service Manual
Appendix A — Specifications
3 Gb/s Digital Video
Table 64 contains the specifications for the 3 Gb/s Digital Video modules.
Table 64. 3 Gb/s Video
Inputs (Excluding MON IN connection)
Type Serial digital video conforming to SMPTE 259M, SMPTE 292M, or SMPTE 424M
Connector BNC 75 ohm
Return loss >15db to 5 MHz to1.5GHz, >10 dB 1.5GHz to 3GHz.
DC offset 0 V (AC coupled) ± 0.5 V
Impedance 75 ohms
Cable equalization Automatic ≥ 80 meters of Belden 1694A or equivalent
Outputs (Excluding MON OUT connection)
Type Serial digital video conforming to SMPTE 259M, SMPTE 292M, or SMPTE 424M
Connector BNC 75 ohm
Return loss 15db to 5 MHz to1.5GHz, >10 dB 1.5GHz to 3GHz.
Signal amplitude 800 mV ±10% when terminated into 75 ohm
Impedance 75 ohms
DC offset 0 V (AC coupled) ± 0.5 V
Operational Modes
Reclocking Automatic or manual selection of 270 Mbps, 1.5 Gbps, 3 Gbps.
Non-standard bit rates Non-reclocked operation or bypass switched from 10 Mbps to 700 Mbps with signals that have a maximum
ones/zeros ratio of 20:1
Performance
Input-to-output delay 128x128 < 15nS
Minimum Rise/Fall time < 135 pS (correct by design)
Vertical interval switch Reference 1
(normal single sync) 525 Line Standard Field switching Line 10 and Line 273. Middle of line 625 Line Standard Field switching:
Line 6 and Line 319. Middle of line ±5 µsec.
Reference 2
(dual sync switching) 525 Line Standard Field switching Line 10 and Line 273. Middle of line ±10 µsec. 625 Line Standard Field
switching Line 6 and Line 319. Middle of line ±10 µsec.
Dual sync Automatic vertical interval switched relative to the reference (software assignable on output-by-output basis)
Monitor Input
Signal source Concerto monitor outputs only
Type Serial digital video conforming to SMPTE 259M, 292M, 424M for 270Mb/S, 1.5Gb/S and 3Gb/S
Connector BNC 75 ohm
Return loss >15 dB; 20 dB typical (10 MHz-360 MHz)
Connector BNC 75 ohm
Quantity 1 (per module)
Cable length
80 meters of Belden 1694A
Monitor Outputs
Type Serial digital video conforming to SMPTE 259M, 292M, 424M for 270Mb/S, 1.5Gb/S and 3Gb/S
Connector BNC 75 ohm
Quantity 1 (per module)
Return loss SD >15db to 5 MHz to1.5GHz, >10 dB 1.5GHz to 3GHz.
Signal amplitude 800 mV ±10% when terminated into 75 ohm
DC offset 0 V (AC coupled)