Grass Valley Concerto Routing Matrix v.1.8.1 - Manual (Page 142)

142 Concerto — Installation and Service Manual
Section 4 — 3GB/s System Information
Troubleshooting
There are several LEDs on the front edge of the 3Gb/s board that should be
used for Troubleshooting. The location for these LEDs is shown in
Figure 80 .
Table 54 provides the needed LED information. The LED names are listed
as they appear on the board.
Figure 80. LED Location
Table 54. 3Gb/s Board LEDs
LED Name Description Indication and Condition
3G When the 3G LED is lit it means that the board is pro-
cessing up to 3 Gb/s signals. On: (BLUE) Processing up to 3
Gb/s signals.
Off: Processing SD or HD sig-
nals only.
DIAG Not used at this time. On: (RED) Diagnostics in pro-
cess (factory use)
Off: Normal use.
OVER TEMP When the OVER TEMP LED is lit it means that the
board’s temperature is too hot. On: (RED) Over temperature.
Off: Normal use.
PARITY ERROR When the PARITY ERROR LED is lit it means that a parity
error has occurred. On: Parity error
Off: Normal use.
ERROR When the ERROR LED is lit it means that a failure has
occurred. If it is not lit, the board condition is normal. On: (RED) Failure.
Off: Normal.
BUSY When the BUSY LED is lit it means that the board is in
use. On: (YELLOW) Indicates an
active board.
Off: Indicates an inactive board.
3Gb/s Board LEDs