Grass Valley Concerto Routing Matrix v.1.8.1 - Manual (Page 113)

Concerto — Installation and Service Manual 113
Ethernet Interface Configuration
IP Address Setting Using Concerto Web Pages
The IP addresses on a Concerto controller can also be changed directly from
its web page; provided the PC used is configured with a compatible IP
address compatible. However, it is more convenient to use NetConfig for
this purpose, because it can list devices even the device is not configured
directly on the network. Refer to the NetConfig Instruction Manual for
detailed information.
If you know the existing IP address of the Concerto Matrix controller, you
can access it from a properly configured computer. Once the Concerto web
page is displayed, the IP address is changed by going to the Network Con-
figuration screen (
Figure 59 ). The Concerto Matrix controller will need to
be reset to make any changes take effect. This is accomplished by checking
the
Do Reset box and then clicking on the Save New Settings button at the
bottom of the screen, as shown in the example screen.
Figure 59. Concerto Matrix Network Configuration
Software Updates
When you’re ready to update Concerto’s software, follow these steps.