Grass Valley Concerto Routing Matrix v.1.8.1 - Manual (Page 132)

132 Concerto — Installation and Service Manual
Section 3 — Control System Configuration
If the setting for this switch is On:
• The Controller in CMS1 will take control as Master, or
• If the Controller in CMS1 fails, the Controller module in CMS2 will
take over, or
• If the Controller in CMS1 is reset, the Controller module in CMS2
will take over until the Controller in CMS1 reboots at which time
the Controller in CMS1 will take control, or
• If there is only one Controller module and it is in CMS2, it will be
Master, or
• If there is one Controller module in CMS2, and a second Controller
module is seated and booted in CMS1, the Controller module in
CMS1 will take control.
If the setting for this switch is Off:
• When there are two Controller modules, whichever one boots the
fastest will be the Master, or
• If there is only one Controller module and it is in either Controller
module slot it will be the Master.
6. Set Level and Options for each slot.
Banks S2, S3, S4, S5, S7, S8, S9, and S10 are used to assign Levels and
Options to the module slots. DIP Switch number 8 is not used on banks
S4, S7, or S8.
Table 49 shows which banks and setting types are used for
each slot.
Table 50 shows the common default level settings used by matrices in
the Jupiter Control System. You can set any of the 127 possible levels;
for the complete set see
Appendix B-Reference Tables . The common levels
shown are the ones supported by Concerto.
Table 49. DIP Switch Bank and Module Slot Number
Module Slot # DIP Switch Bank Setting Type
1
S2 Level
S3 Options
2
S4 Level
S5 Options
3
S7 Level
S8 Options
4
S9 Level
S10 Options