Grass Valley Concerto Routing Matrix v.1.8.1 - Manual (Page 139)

Concerto — Installation and Service Manual 139
Section
4
3GB/s System Information
The Concerto 3Gb/s board supports up to 3Gb/s operations as well as SD
and HD. This board must only be installed in slots with a 3Gb/s rear panel
or damage to the system will occur.
This section covers the Concerto 3 Gb/s specific items. General configura-
tion areas that apply to all matrices connected to a control system are
covered in the Instruction Manuals for the specific control system. That is,
Jupiter, Encore, and Prelude.
The Signal, Physical specifications, and Troubleshooting tasks for the Con-
certo 3Gb/s board is also provided in this section.
Module Installation
All the modules are horizontally oriented in the frames, and edge guides
aid insertion and removal. Modules are oriented in the frame with the front
side facing up.
Installing the 3Gb/s module into a slot with a different, or incompatible,
rear panel may damage either the module or rear panel. Modules should
only be installed in slots with the same type of rear panel.
Install the included Orange 3Gb/s label on the front surface of the left ver-
tical guide rail directly below the HD or 3Gb/s module's slot to avoid pos-
sible equipment damage. The HD label is shown in
Figure 78 on page 140 .