Grass Valley Concerto Routing Matrix v.1.8.1 - Manual (Page 126)

126 Concerto — Installation and Service Manual
Section 3 — Control System Configuration
Encore Control System Configuration
Matrix configuration procedures are dependent upon how the matrix fits
within its resident system and how that system is controlled. If you are
using an Encore Control System you will generally need to follow the
instructions for matrix configuration found in the Encore Configuration
Manual. In some cases, however, you must use specific settings. This
section highlights those distinctions.
CAUTION If you are using a CRS-MC-C2 Controller module, the mode setting on DIP
Switch bank S11 must be set correctly before it will communicate using
Ethernet. See
Control Mode/In Sel Setting on page 109 .
Use the GVG CPL Protocol for Concerto matrices.
Figure 73. Router Protocol
If a Concerto frame contains a mixed-format board set, a different Cros-
spoint Group must be defined for each format. The same controller is used
for all controllers, but there are controller attributes that relate to a specific
Crosspoint Group to specific boards in the Concerto frame.