Grass Valley Concerto Routing Matrix v.1.8.1 - Manual (Page 116)

116 Concerto — Installation and Service Manual
Section 3 — Control System Configuration
Control Options
The Control options settings that are available are Standard , Standalone , and
Native Protocol . Most Concerto systems will run under Standard Control.
Standalone and Native Protocol settings are used when the Concerto
system is directly controlled by an automation system or other external
control point.
Note Native Protocol cannot be used with Concerto Port Routers to perform bi-
directional Takes.
If Standalone is selected, additional settings become available on the Local
Control web page (see Figure 77 on page 136 ).
Matrix Reference Configuration
The Matrix Reference Configuration page reports the status of the system’s
video reference. The signal type is automatically detected and cannot be
changed from this page.
Figure 62. Matrix Reference Configuration Web Page
Frame Count Server
A Frame Count Server feature can be used with Grass Valley Prelude
systems (not Encore systems) to synchronize frame boundary Takes initi-
ated from system control panels. For Prelude control, the
Broadcast frame
count setting should be Enabled .
On Encore systems, the Broadcast frame count setting should be Disabled on
Concerto, and any other matrices controlled by Encore, to prevent conflicts.