Native protocol configuration – Grass Valley Concerto Routing Matrix v.1.8.1 User Manual
Page 135
Concerto — Installation and Service Manual
135
Native Protocol Configuration
Native Protocol Configuration
Note
The Concerto Native Protocol feature is intended for third party developers.
Developers can refer to the separate Routing Products Protocols Manual for
specific information about NP commands. Existing customers should use
Standard Control on their Encore systems.
CAUTION A Concerto Matrix operating under Native Protocol supports a maximum of
24 clients. Exceeding this number can interfere with Concerto web server
access and software update via NetConfig.
Native Protocol (NP) Index commands are supported in the 1.7.5 version of
Concerto and newer. Concerto web pages will have settings for local con-
figuration if NP is used. Native Protocol cannot be used with Concerto Port
Routers to perform bi-directional Takes. A Concerto matrix can now
operate under
Standard Control
, operate only with NP (
Standalone
control
option), or both standard and NP control (
Allow Native Protocol Control
). These
settings are selected with the
Control Options
located on the Concerto System
Configuration web page (
).
Figure 76. Concerto Standalone Control Setting.
If the
Standalone Control
setting is selected and saved, the Concerto Local
Configuration web page is available that allows local matrix configuration
(