Grass Valley Concerto Routing Matrix v.1.8.1 - Manual (Page 121)

Concerto — Installation and Service Manual 121
SMS7000 Control System Configuration
Specifying the Concerto Matrix frame type enables the Concerto Frame Boards
button above the Frm column. Click the number in the Slice column to select
the slice you’re configuring. Then click the Boards button to open the Boards
for Slices n dialog box ( Figure 68 ).
Figure 68. Boards for Slices Dialog
In the Boards in Frame column on the left, select the board(s) you want in this
slice. All of the boards in a slice must be contiguous and compatible, but not
necessarily identical (Analog Audio and Digital Audio modules can be in
the same slice, also Digital Video and HD Video can be in the same slice).
Click the
Add >> button or use the Add All button as appropriate. For more
information on slices and the types of boards that can be included in a slice,
see
Optimum Matrix Configurations on page 38 . You can also use the Remove
buttons to change your mind. The Boards in Exp Frame section of this dialog
is reserved for future use. Click the OK button to finalize your choices.
A slice must be created for each signal type.
Follow these steps to create additional slices:
1. Click on the first column to highlight it (see Figure 69 )
• Press the I key to insert a row.
• Press the A key to append a row
• Press the D key to delete a row.
2. Follow these steps for additional signal types.