H3C Technologies H3C S5830V2 Series Switches User Manual

Page 95

# Enable FCoE for VLAN 10, and map VLAN 10 to VSAN 2.

[SwitchA] vlan 10

[SwitchA-vlan10] fcoe enable vsan 2

[SwitchA-vlan10] quit

# Enable FSPF for VFC 1.

[SwitchA] interface vfc 1

[SwitchA-Vfc1] undo fspf silent vsan 2

[SwitchA-Vfc1] quit

Configure Switch B
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)

system-view

[SwitchB] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Save the configuration.

[SwitchB] save

The current configuration will be written to the device. Are you sure? [Y/N]:y

Please input the file name(*.cfg)[flash:/startup.cfg]

(To leave the existing filename unchanged, press the enter key):

Validating file. Please wait...

Saved the current configuration to mainboard device successfully.

[SwitchB] quit

# Reboot the switch.

reboot

Start to check configuration with next startup configuration file, please

wait.........DONE!

This command will reboot the device. Continue? [Y/N]:y

Now rebooting, please wait...

# Configure the switch to operate in FCF mode.

system-view

[SwitchB] fcoe-mode fcf

# Create VSAN 2 and enable the fabric configuration function for VSAN 2.

[SwitchB] vsan 2

[SwitchB-vsan2] domain configure enable

# Configure the domain ID as 2 for the switch.

[SwitchB-vsan2] domain-id 2 static

# Enable FSPF globally.

[SwitchB-vsan2] fspf enable

[SwitchB-vsan2] quit

# Create interface VFC 1.

[SwitchB] interface vfc 1

# Configure the mode of VFC 1 as E.

[SwitchB-Vfc1] fc mode e

# Bind VFC 1 to interface Ten-GigabitEthernet 1/0/1.