H3C Technologies H3C S5830V2 Series Switches User Manual
Page 83
72
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
[SwitchC] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchC] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchC] quit
# Reboot the switch.
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
[SwitchC] fcoe-mode fcf
# Enable the fabric configuration function for VSAN 1.
[SwitchC] vsan 1
[SwitchC-vsan1] domain configure enable
# Configure the domain ID as 3.
[SwitchC-vsan1] domain-id 3 static
[SwitchC-vsan1] quit
# Change Ethernet interface Ten-GigabitEthernet 1/0/2 into FC interface FC 1/0/2.
[SwitchC] interface ten-gigabitethernet 1/0/2
[SwitchC-Ten-GigabitEthernet1/0/2] port-type fc
# Configure the mode of interface FC 1/0/2 as E.
[SwitchC-Fc1/0/2] fc mode e
# Configure interface FC 1/0/2 to autonegotiate the speed.
[SwitchC-Fc1/0/2] speed auto
# Configure the trunk mode of interface FC 1/0/2 as On, and assign interface FC 1/0/2 to
VSAN 1 as a trunk port.
[SwitchC-Fc1/0/2] port trunk mode on
[SwitchC-Fc1/0/2] port trunk vsan 1
[SwitchC-Fc1/0/2] quit
# Enable FCoE for VLAN 10, and map VLAN 10 to VSAN 1.
[SwitchC] vlan 10
[SwitchC-vlan10] fcoe enable vsan 1
[SwitchC-vlan10] quit