H3C Technologies H3C S5830V2 Series Switches User Manual

Page 88

# Configure Ten-GigabitEthernet 1/0/2 as a trunk port, and assign the port to VLAN 10.

[SwitchB] interface ten-gigabitethernet 1/0/2

[SwitchB-Ten-GigabitEthernet1/0/2] port link-type trunk

[SwitchB-Ten-GigabitEthernet1/0/2] port trunk permit vlan 10

[SwitchB-Ten-GigabitEthernet1/0/2] quit

# Enable FCoE for VLAN 10, and map VLAN 10 to VSAN 1.

[SwitchB] vlan 10

[SwitchB-vlan10] fcoe enable vsan 1

[SwitchB-vlan10] quit

# Configure two static routes on Switch B.

[SwitchB] vsan 1

[SwitchB-vsan1] fc route-static 010000 8 vfc 1

[SwitchB-vsan1] fc route-static 030000 8 vfc 2

Configure Switch C:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)

system-view

[SwitchC] system-working-mode advance

Do you want to change the system working mode? [Y/N]:y

The system working mode is changed, please save the configuration and reboot the

system to make it effective.

# Save the configuration.

[SwitchC] save

The current configuration will be written to the device. Are you sure? [Y/N]:y

Please input the file name(*.cfg)[flash:/startup.cfg]

(To leave the existing filename unchanged, press the enter key):

Validating file. Please wait...

Saved the current configuration to mainboard device successfully.

[SwitchC] quit

# Reboot the switch.

reboot

Start to check configuration with next startup configuration file, please

wait.........DONE!

This command will reboot the device. Continue? [Y/N]:y

Now rebooting, please wait...

# Configure the switch to operate in FCF mode.

system-view

[SwitchC] fcoe-mode fcf

# Enable the fabric configuration function for VSAN 1.

[SwitchC] vsan 1

[SwitchC-vsan1] domain configure enable

# Configure the domain ID as 3 for Switch C.

[SwitchC-vsan1] domain-id 3 static

[SwitchC-vsan1] quit

# Create interface VFC 2.

[SwitchC] interface vfc 2