H3C Technologies H3C S5830V2 Series Switches - Manual (Page 111)

100
• Server A does not access any disk but might need to subsequently.
• Server B can access Disks A, B, and C.
• Server C can access Disks B and C.
• Servers cannot access each other.
Figure 32 Network diagram
Requirements analysis
To meet the preceding requirements, divide VSAN 1 into three zones as follows:
• Zone 1 contains Server A.
• Zone 2 contains Server B and Disks A, B, and C.
• Zone 3 contains Server C and Disks B and C.
Configure Switch A and distribute the full zone database to Switch B:
• Create zone alias Alias 1, which contains Disks B and C, to simplify the configuration.
• Create zone set Zoneset 1, which contains Zones 1, 2, and 3, and activate it.
Configuration procedure
This section describes only the FC zone configurations on Switch A. You do not need to configure FC
zones on Switch B.
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.