H3C Technologies H3C S5830V2 Series Switches - Manual (Page 80)

69
FC routing configuration examples
Static FC routing configuration example by using FC interfaces
Network requirements
As shown in Figure 24 , configure static routes so any two FC switches can communicate with each other.
Figure 24 Network diagram
Configuration procedure
This section describes only the FC routing configurations.
1. Configure Switch A:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
system-view
[SwitchA] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchA] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchA] quit
# Reboot the switch.
reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
Switch B
Switch A
FC1/0/1
XGE1/0/1
Switch C
Domain ID: 1 Domain ID: 3
Domain ID: 2
FC1/0/1
XGE1/0/1
FC1/0/2
XGE1/0/2
FC1/0/2
XGE1/0/2