Stopping a topology discovery, Displaying and maintaining fcs, Fcs configuration example – H3C Technologies H3C S5830V2 Series Switches User Manual
Page 137: Network requirements
126
To start a topology discovery:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Start a topology
discovery in
specified VSANs.
fcs discovery start [ age
interval ] vsan vsan-list
You can start a second topology discovery for the
same VSAN only after the first topology discovery is
complete. Otherwise, the system displays the
message "FCS discovery is being performed".
Stopping a topology discovery
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Stop a topology
discovery in specified
VSANs.
fcs discovery stop vsan vsan-list
After you execute the command, the
system performs the following
operations:
•
Stops the topology discovery in
progress.
•
Deletes the topology information
obtained from non-local
switches.
•
Changes the topology discovery
status back to localOnly.
Displaying and maintaining FCS
Execute display commands in any view.
Task Command
Display the topology discovery status.
display fcs discovery status [ vsan vsan-id ]
Display the FCS database information.
display fcs database [ vsan vsan-id ]
Display IE information.
display fcs ie [ vsan vsan-id ] [ nwwn wwn ] [ verbose ]
Display port information.
display fcs port [ vsan vsan-id ] [ pwwn wwn ]
[ verbose ]
FCS configuration example
Network requirements
As shown in
, start a topology discovery to obtain topology information in the fabric for the
management application.