Verifying the configuration – H3C Technologies H3C S5830V2 Series Switches User Manual
Page 69
58
# Configure the domain ID as 13.
[SwitchC-vsan1] domain-id 13 preferred
Non-disruptive reconfiguration or isolating the switch may be performed. Continue?
[Y/N]:y
4.
Configure Switch D:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
[SwitchD] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
# Save the configuration.
[SwitchD] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchD] quit
# Reboot the switch.
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
# Configure the switch to operate in FCF mode.
[SwitchD] fcoe-mode fcf
# Enable the fabric configuration function for VSAN 1. This step is optional because the fabric
configuration function is enabled by default.
[SwitchD] vsan 1
[SwitchD-vsan1] domain configure enable
# Configure the domain ID as 14.
[SwitchD-vsan1] domain-id 14 preferred
Non-disruptive reconfiguration or isolating the switch may be performed. Continue?
[Y/N]:y
Verifying the configuration
Verify the configuration on switches, for example, Switch A.
# Display the domain information of VSAN 1.
[SwitchA-vsan1] display fc domain vsan 1
Domain Information of VSAN 1:
Running time information:
State: Stable
Switch WWN: 48:33:43:2d:46:43:1A:1A