H3C Technologies H3C S5830V2 Series Switches - Manual (Page 63)

52
Configuring the default FC4 information for a node
If a node does not register FC4 information and the switch fails to obtain SCSI-FCP information from the
node, the switch records the default FC4 information in the name service database for that node. When
a node registers FC4 information or the switch obtains the SCSI-FCP information, the switch replaces the
default FC4 information with the registered FC4 information or obtained SCSI-FCP information.
The fc wwn default-fc4-type command can configure only one combination of FC4-Type and Feature at
a time.
To configure the default FC4 information for a node:
Step Command Remarks
1. Enter system view. system-view N/A
2. Configure the default
FC4 information for a
node.
fc wwn wwn-value default-fc4-type
{ type-value feature feature-map |
scsi-fcp feature { feature-map | both |
initiator | target } }
By default, no default FC4
information is configured.
Displaying and maintaining a fabric
Execute display commands in any view.
Task Command
Display the domain information of the specified
VSAN.
display fc domain [ vsan vsan-id ]
Display the list of domain IDs dynamically allocated in
the specified VSAN.
display fc domain-list [ vsan vsan-id ]
Display fabric timers.
display fc timer [ distributed-services | error-detect |
resource allocation ] [ vsan vsan-id ]
Display node login information. display fc login [ vsan vsan-id ] [ count ]
Display the SCR table for an N_Port. display fc scr-table [ vsan vsan-id ] [ count ]
Display name service database information.
display fc name-service database [ vsan vsan-id [ fcid
fcid ] ] [ verbose ]
display fc name-service database [ vsan vsan-id ]
count
Display ESS negotiation results. display fc ess [ vsan vsan-id ]
Fabric building configuration examples
Static fabric building configuration example
Network requirements
As shown in Figure 22 , use the static method to build a fabric.