Configuring switch c – H3C Technologies H3C S5830V2 Series Switches User Manual
Page 184
173
[SwitchA-Vfc11] quit
# Enable FCoE for VLAN 4001, and map VLAN 4001 to VSAN 100.
[SwitchA] vlan 4001
[SwitchA-vlan4001] fcoe enable vsan 100
[SwitchA-vlan4001] quit
# Enable FCoE for VLAN 4002, and map VLAN 4002 to VSAN 200.
[SwitchA] vlan 4002
[SwitchA-vlan4002] fcoe enable vsan 200
[SwitchA-vlan4002] quit
# Enter the view of VSAN 100, and configure the members in the default zone to access each
other.
[SwitchA] vsan 100
[SwitchA-vsan100] zone default-zone permit
[SwitchA-vsan100] quit
# Enter the view of VSAN 200, and configure the members in the default zone to access each
other.
[SwitchA] vsan 200
[SwitchA-vsan200] zone default-zone permit
[SwitchA-vsan200] quit
Configuring Switch C
1.
Enable the advanced mode:
# Configure the switch to operate in advanced mode. (Skip this step if the switch is operating in
advanced mode.)
[SwitchC] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the system
to make it effective.
# Save the configuration.
[SwitchC] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
[SwitchC] quit
# Reboot the switch.
Start to check configuration with next startup configuration file, please
wait.........DONE!
This command will reboot the device. Continue? [Y/N]:y
Now rebooting, please wait...
2.
Configure VLANs and interfaces:
# Create 4001, which is intended to transmit storage traffic.
[SwitchC] vlan 4001